Torch 1.0 Road Shoes: Fit and Cleat Setup Tips
By Specialized Retail AU | Published: 2026-11-03
Category: ハウツーガイド
Learn how to fit the Torch 1.0 Road Shoes and dial in your cleat position. A step-by-step guide for a comfortable, efficient ride.
Quick answer
Start with the right size and width, then set your cleats based on your natural foot angle and pedaling style. A methodical fit and cleat position will make the Torch 1.0 Road Shoes comfortable and efficient from the first ride.
Why the BOA dial matters for fit
The Torch 1.0 uses a single BOA L6 dial with tool-free snap replacement. That means you can fine-tune tension on the fly, but it also means you should avoid over-tightening—the dial's micro-adjustments are best used to take up slack gradually, not to crank down hard. A common mistake is to tighten the dial until the shoe feels snug, then leave it; instead, adjust after a few minutes of riding as your foot settles.
Width options and when to size up
The Torch 1.0 is available in multiple widths, so don't assume your standard size will fit. If you have a wider forefoot or high instep, try the wider width before going up a size—extra length won't fix pressure points. Conversely, if the shoe feels loose around the heel but snug at the toes, a different width or a volume adjustment with the BOA dial is the better fix.
Step-by-step fit and cleat setup
- Measure your feet: Stand on a piece of paper and mark your heel and longest toe. Measure the distance in millimeters and compare to the size chart. Do this later in the day when feet are slightly larger. Check both feet—most people have one foot slightly longer.
- Try on with your riding socks: Put on the socks you'll wear on the bike. Slide your foot into the shoe and press your heel to the back. You should have about a thumb's width (10–15 mm) of space at the toe. If your toes touch the front, go up a size or try a wider width.
- Adjust the BOA dial: With the shoe on, turn the dial clockwise to tighten until you feel even pressure across the top of your foot. Don't over-tighten; you should be able to wiggle your toes slightly. The dial should turn smoothly—if it feels gritty, the lace may be misrouted.
- Check heel hold: Stand and lift your heels. Your heel should stay seated without slipping. If it lifts, tighten the dial a quarter turn or consider a different width. Excessive heel slip can cause blisters—address it before riding.
- Set initial cleat position: Most cleats have a mark for the ball of your foot. Align the cleat so the pedal axle sits just behind the ball of your foot. Start with the cleat centered side-to-side. Use a marker to note your starting position so you can adjust later.
- Check cleat angle: Sit on a chair and let your feet hang naturally. Note the angle of your forefoot. Set your cleats to match that angle—typically slightly toed-out for most riders. Forcing your feet into a straight position can cause knee pain.
- Test and fine-tune: Go for a short ride on a quiet road. Pay attention to any pressure points or instability. Adjust cleat fore/aft or angle in small increments (1–2 mm) until comfortable. Bring the tools you need for cleat adjustment on your first few rides.
Product facts
- Torch 1.0 Road Shoes: Single BOA L6 dial with tool-free snap replacement and on-the-fly micro-adjustments. You can easily fine-tune fit during a ride, and replace the dial without tools if needed.
Torch 1.0 Road Shoes - Torch 1.0 Road Shoes: Body Geometry sole construction and footbeds are ergonomically designed. The footbed and sole shape support your foot's natural alignment, which can reduce discomfort on longer rides.
