Gambit Replacement Visor: Selection & Install Guide

Quick answer

Select the Gambit Replacement Visor in your helmet's size (S, M, or L) and preferred color (Black or Oak Green), then snap it into the front visor slots until it clicks. No tools required.

How to install the Gambit Replacement Visor

1. 1. Check your helmet size: Look inside your Gambit helmet for the size sticker (S, M, or L). Order the visor in the same size. A mismatch can cause poor fit or snapping issues. Double-check the size before ordering—the visor is not adjustable.
2. 2. Remove the old visor: Grip the old visor near the mounting points and pull it away from the helmet. It should pop off with moderate force. If it's stuck, use a flat plastic tool to gently pry it loose—avoid metal tools that could scratch the helmet shell. Work slowly to avoid damaging the helmet's visor slots.
3. 3. Align the new visor: Hold the replacement visor so its mounting tabs line up with the slots on the front of the helmet. The visor's curved edge should match the helmet contour. If the visor seems to sit crooked, you may have the wrong size or the tabs are not fully seated.
4. 4. Snap into place: Press firmly and evenly on both sides of the visor until you hear a click. Run a finger along the seam to confirm it's flush. If one side pops up, press it again until it locks. A secure click means the visor is fully engaged—no further tightening needed.
5. 5. Test the fit: Wear the helmet and tilt your head forward and side to side. The visor should stay in place without shifting. If it rattles, remove it and check that the tabs are straight and undamaged. A loose visor could detach on the trail—re-seat or replace if it doesn't lock firmly.

Product details

• Gambit Replacement Visor: Direct replacement visor for the Gambit helmet, available in Black or Oak Green, offered in S, M, and L sizes. Ensures a snug, rattle-free fit and correct coverage whether you're replacing a worn part or customizing your helmet's appearance.